Fixing TPE Dolls

Customers are concerned about dents, tears, and scratches on the skin of dolls. In this article, we will learn how to fix these issues to make the TPE doll as good as new.

Repairing Indentations

There are

In cases where heavy objects are placed on top of a sex doll or if it has been placed in an unproper position, dents can be formed on the surface of the sex doll. There are two ways to fix these dents:

A Hot Towel

Cover the tooth with a clean, hot towel for a while.

Wearing white gloves, pat the dent with your hands until the dent goes away.

A Hair Dryer

You should cover the area where the pressure mark is located with a white, damp cloth or towel.

Heat the surface using the hair dryer for some time.

Gradually, the dents and indentations on the surface of the doll will begin to disappear.

How to Repair Tears and Scratches
Tears, whether

Your doll can suffer structural damage from accidental cuts by sharp objects and improper usage. The following are the ways you can fix the damage:

TPE Repair Solvent

The purpose of the TPE repair solvent is to repair the skin damage on the TPE dolls by melting the surface of the TPE, much like welding, to fuse the sides together when closed.

How to Use:

The area around the wound should be cleaned using a damp cloth to eliminate dirt and excess oil.

Open the wound with your fingers. Apply a thin layer of TPE Repair Solvent to the inner surface of the wound with the cotton swab provided.

Immediately position the wound correctly and seal it for a few minutes to allow the TPE repair fluid to melt the edges together. Push the skin until the wound closes.

Let the wound heal for 24 hours. Make sure the doll is positioned in such a way that there is no tension on it while the curing takes place.

Warning:

TPE Repair Solvent is quite strong and may damage TPE. Use with care.

TPE repair solvent should never be poured or dripped directly onto the doll.

It is always advisable to apply the repair solvent using a cotton swab or toothpick.

Heat Gun

A heat gun is also a good way to fix general scratches on TPE sex dolls. It is recommended to use an infrared heat gun with a temperature sensor for temperature feedback during the process.

How to Use:

Preparation of the Surface: -- Clean the skin surface with baby oil or petroleum jelly to better distribute the heat. Apply the oil to keep the doll from burning from the heat gun.

Heating: -- Wear a mask for safety reasons. -- Target the heat gun on the damaged part while keeping it a distance of around four inches away from it. -- Heat the TPE heart-shaped doll to the desired temperature (about 110°C). Once you attain the right temperature, a mirror-like glaze will be formed. Heating will be completed when you witness the appearance of smoke.

⚠️Tip: Prior to heating the skin of the doll, practice using a heat gun on a sample piece of TPE material to learn its melting point parameters. Smoothing: Gently remove scratches with a cloth. Since the temperature cools quickly, you have 30 seconds to remove scratches. Repeat the steps of heating and cooling endlessly for a smooth surface finish. Every time you do this, the skin will become smoother. Tip: Apply oil after each round, since the TPE doll will dry up due to the processes of repeated heating and cooling. Fine Finishing: -- Use a bit of powder to give an overall perfect makeup look. These tools are best suited for neck or leg tears, arm tears, or general skins. For minor cuts or tears on the face of the dolls, experienced users may also opt for the same. But new users may purchase a new head for the sex dolls. (Video: “How to Repair Skin”))